Struers LaboPol-20 - Monthly; Laboforce-50 - Pressure Feet; Annually; Test the Safety Devices

9.4 Monthly
9.4.1 LaboForce-50 - pressure feet
The force on the pressure feet is generated by friction pins held in place by the screws in the
spring housing.
• Use an Allen key to tighten the screws.
A Screws
9.5 Annually
9.5.1 Test the safety devices
The safety devices must be tested at least once a year.
WARNING
Do not use the machine with defective safety devices.
Contact Struers Service.
WARNING
Safety critical components must be replaced after a maximum lifetime of 20 years.
Contact Struers Service.
Note
Testing should always be performed by a qualified technician (electromechanical,
electronic, mechanical, pneumatic, etc.).
9 Maintenance and service
LaboPol-20 41