Service Information
10
BIG WHEEL HUBCAP REMOVAL
Required Tools:
Large Standard Screwdriver
1. Using a large standard screwdriver, pry evenly around the entire edge of the Big Wheel hubcap until it
pops off the mounting studs on the wheel.
CAUTION
Do not attempt to pull off the hubcap after prying up only one side. Damage to the slots on the hubcap or
the mounting studs on the wheel could result.
2. To reinstall the hubcap, place it on the wheel, aligning the slots in the hubcap with the mounting studs
on the wheel. Press down evenly on the edges of the hubcap until it snaps into place.
BIG WHEEL REMOVAL
Required Tools:
Large Standard Screwdriver Small Standard Screwdriver String or Bungee Cords
1. Lift the base hood and separate the Velcro holding it to the base frame. Support the hood from the litter
using bungee cords so it is out of the way.
2. Using a large, standard screwdriver, pop off the big wheel cover.
3. Using a small, standard screwdriver, remove the spiral retaining ring from the groove on the Big Wheel
axle.
4. Remove the Big Wheel.
5. Reverse steps 1−4 to reinstall the Big Wheel.
To Next Page
Loading...
