Operations Manual
16
• Hi-Lo Switches (D1 and D2)
These two switches enable adjustment of the sleep surface height (Hi-Lo).
D1: Push to raise the sleep surface.
D2: Push to lower the sleep surface.
• Trendelenburg Switch (E)
This switch, when activated, enables both Trendelenburg positions through the Hi-Lo
switches. A lighted green LED on the pictogram indicates that Trendelenburg positioning is
available.
E: Push to activate the Trendelenburg positions, which then become available through the
Hi-Lo switches.
Trendelenburg: Push switch D1 to lower head end/raise foot end of the bed.
Reverse Trendelenburg: Push switch D2 to lower foot end/raise head end of the bed.
N
N
O
O
T
T
E
E
To replace the sleep surface in horizontal position after Trendelenburg positioning, simply press
the Trendelenburg switch to deactivate the function (green LED will go out) and lower or raise
the sleep surface to its limit. Then position the bed to the desired height.
• Auto Contour (optional) Pictogram (F)
This figure, illustrating the Auto Contour position, points to the lockout switch to activate in
the foot board control panel to allow Auto Contour positioning.
Auto Contour positioning automatically raises the Knee Gatch as the Fowler raises. This
position prevents the patient from slipping towards the foot of the bed when the Fowler is
inclined.
F: As indicated by the pictogram arrow, push the Knee Gatch lockout switch (A2, LED will
light up) to enable the Auto Contour positioning.
N
N
O
O
T
T
E
E
To obtain the Auto Contour positioning from a siderail control panel, both Knee Gatch and
Fowler controls must be made available to siderail control panels through deactivating their
respective lockout switches (A1 and A2, LEDs will light up) in the foot board control panel.
To Next Page
Loading...
