To Next PageTo Next Page
Need help?Do you have a question about the Stryker Bertec FL13E Series and is the answer not in the manual?
General| Brand | Stryker |
|---|---|
| Model | Bertec FL13E Series |
| Category | Medical Equipment |
| Language | English |
Provides essential safety, maintenance, and usage information, plus contact details for inquiries.
Defines symbols and terms used throughout the guide for clarity and understanding.
Outlines maneuvers to avoid and recommendations for safe operation and patient care.
Details recommended use, model identification, material description, and bed specifications.
Covers switching on power and provides a checklist for basic bed operations.
Explains how to raise/lower the sleeping surface and its sections using the nursing control center.
Details how to achieve Trendelenburg and Reverse Trendelenburg positions using a clutch lever and bed commands.
Describes how to set the foot section of the sleeping surface to a horizontal position.
Explains how to move the bed using different locking systems: central locking, total braking, and directional steering.
Provides instructions for removing and replacing the headboard and footboard.
Explains the locking system and how to lower/raise half-length safety side-rails.
Details the locking system and operation for full-length safety side-rails.
Describes how to install removable safety nets on full-length safety side-rails.
Explains the optional electric control on the footboard for bed adjustments.
Details optional patient controls on side-rails for adjusting the sleeping surface.
Explains how contour positioning automatically controls thigh section angle relative to head section.
Describes the nurse call button on the side-rail for summoning assistance.
Explains the emergency feature for immediate return of the head section to horizontal.
Details how to use immobilizer legs for complete immobility and stability in emergencies.
Explains how to use the emergency crank handle for adjusting sleeping surface positions during power failure.
Describes optional movable patient controls on side-rails for adjusting the sleeping surface.
Details the installation and use of I.V. rods and trapeze mounting for patient support.
Covers regular cleaning, maintenance checks for bolting, and lubrication procedures.
Provides a checklist of common problems, their possible causes, and solutions.
Details the warranty coverage for Bertec products against defects and provides contact information.
Outlines the procedure for identifying and ordering replacement parts for the bed.
Instructions for removing and replacing sections of the bed's sleeping surface.
Procedures for replacing the entire mechanism or just the upper section of half-length side-rails.
Instructions for replacing the entire full-length side-rail or its upper section.
Detailed steps for replacing the bed's motors, including disconnection and reconnection.
Guide for replacing the translating screw for the head section of the bed.
Instructions for replacing the translating screw for the thigh section of the bed.
Steps for replacing the control cable for the instant CPR release feature.
Procedures for replacing micro-switches located on the bed frame and under the sleeping surface.
Provides a detailed wiring and connection diagram for the bed's electrical components.
