Stryker Bertec FL13E Series - Nursing Control Centre; Fixed Patient Control; Contour Positioning

STRYKER MEDICAL/BERTEC MÉDICAL 2 - 11
USER GUIDE
Options
NURSING CONTROL CENTRE
An optional electric control located on the footboard allows care givers to
adjust height of sleeping surface and modify angles of head and thigh
sections.
This control activates the nursing control centre’s bed elevation commands
when the footboard is in place. When the footboard is removed, use
commands on the nursing control centre located on bed frame.
FIXED PATIENT CONTROL
FIXED CONTROL ON HALF-LENGTH SAFETY SIDE-RAIL
Optional patient controls installed on safety side-rails allow patient or care
giver to adjust sleeping surface from the head of bed.
TO RAISE OR LOWER SLEEPING SURFACE
■ Press the arrow corresponding to desired adjustment of sleeping
surface or each section.
The patient selective lock-out on the nursing control centre
located at the foot of the bed must be in the “ON” position
for each patient option on patient control.
MOVABLE CONTROL ON HALF-LENGTH SAFETY SIDE-RAIL
Refer to Accessories section, page 2-14.
This control requires a permanent support device offered as an
option. The support device must be installed when bed is acquired
or following the purchase, at a later date, of a half-length safety
side-rail for installation at the head of bed.
CONTOUR POSITIONING
Contour positioning automatically controls the angle of the thigh section
in relation to the angle of the head section.
TO ACTIVATE THE CONTOUR POSITIONING MECHANISM
■ Set the patient control foot section switch located at the foot of the
bed to the “ON” position.
The contour positioning mechanism is identified by a sticker
located near controls on beds equipped with this option.
CONTOUR