Appendix A: Fixing Boards Permanently
20
Appendix A: Fixing Board Permanently
Tool necessary:
7/16" Wrench
Procedure:
One or both boards can be fixed permanently to the bed frame.
Two 1/4" flat washers, two 1/4" spring washers and two 1/4-20 x 1 3/4" hexagon bolts are
needed for the head board. Two 1/4" flat washers, two 1/4" spring washers and two 1/4-20 x 2
1/4" hexagon bolts are needed for the foot board.
Simply insert the appropriate bolt and the two washer types in the factory-installed nut
accessible through holes (A) located on the inner sides of the foot end and the head end
casings.
N
N
O
O
T
T
E
E
Do not permanently install boards when beds are used in care units where patient may require
emergency treatments.
Figure A
To Previous Page
Loading...
