Stryker FL23SE - User Manual

Questions and Answers

A
Audrey WashingtonAug 7, 2025
What to do if Stryker FL23SE bed has no power?
- J
  Jamie ScottAug 8, 2025
  If your Stryker Medical Equipment bed has no power, check the following: * Ensure the bed power switch at the head end is turned on. * Verify the power cord is connected to both the power connector and the wall outlet. * Inspect the power cord for any damage and replace it if necessary. * Check the two fuses inside the power connector to see if they are operational. * Confirm that there is power at the wall outlet.
B
bakerlaurenAug 12, 2025
Why is there no bed up or down motion on my Stryker FL23SE?
- R
  Raymond SmithAug 12, 2025
  If there's no bed up or down motion on your Stryker Medical Equipment, first check if the Hi-Lo lockout is activated (LED off). If it is, deactivate it (LED on). Also, ensure the cable of the removable pendant control (if equipped) is properly connected to the bed connector under the mattress support. Finally, check points related to the 'No power to bed' problem.
V
Valerie HunterAug 16, 2025
Why is there no Fowler up or down motion on my Stryker Medical Equipment?
- S
  singhzacharyAug 16, 2025
  If there's no Fowler up or down motion on your Stryker Medical Equipment, first check if the Fowler lockout is activated (LED off). If so, deactivate it (LED on). Also, ensure the cable of the siderail control panel or the removable pendant control (if equipped) is properly connected to the bed connector under the mattress support. Finally, check points related to the 'No power to bed' problem.
A
Anthony JamesAug 20, 2025
What to do if Stryker FL23SE Fowler does not fully raise?
- A
  Amy HobbsAug 20, 2025
  If the Fowler on your Stryker Medical Equipment does not fully raise, it may be because the CPR emergency release was used to partially lower it. Lower the Fowler completely using a CPR handle or the Fowler electric control. This will enable the Fowler motor to reset itself and synchronize with the actual position of the Fowler.
B
Brenda HunterAug 25, 2025
Why is there no Knee Gatch up or down motion on my Stryker FL23SE Medical Equipment?
- P
  pprestonAug 25, 2025
  If there's no Knee Gatch up or down motion on your Stryker Medical Equipment, first check if the Knee Gatch lockout is activated (LED off). If it is, deactivate it (LED on). Also, ensure the cable of the siderail control panel or the removable pendant control (if equipped) is properly connected to the bed connector under the mattress support. Finally, check points related to the 'No power to bed' problem.
J
joseph49Aug 28, 2025
What causes difficulty in operating positioning mechanisms of Stryker Medical Equipment?
- C
  Cory ScottAug 29, 2025
  If the Fowler, Knee Gatch, and/or bed height mechanisms of your Stryker Medical Equipment operate with difficulty, check the four actuator screws to verify their lubrication condition and apply grease if needed.
W
williamstriciaSep 2, 2025
What to do if there is no Auto Contour motion on Stryker FL23SE?
- K
  Katelyn MillerSep 2, 2025
  If there is no Auto Contour motion on your Stryker Medical Equipment, first check if the Knee Gatch lockout is activated (LED off). If so, deactivate it (LED on).