www.stryker.com 72-1048E MM FL23SE REV A 13
Return To Table of Contents
______
______
______
______
______
______
______
______
______
______
______
______
______
______
______
______
______
______
______
All fasteners secure.
Inspect for excessive wear the oil-impregnated bronze shoulder spacers found at the bed hinge points.
Replace as needed. Do not lubricate these spacers.
On both sides of the bed, depress fully down the side of the pedal identified with a red sticker and ensure
that the brakes are applied and the bed immobilized. Toggle the pedal to neutral and ensure the brakes
are released.
On both sides of the bed, depress fully down the side of the pedal identified with a green sticker and ensure
that the steer mode (fifth wheel (optional) or bed wheel) is engaged. Toggle the pedal to neutral and ensure
that the steer mode disengages.
Siderails move smoothly and latch properly in high position.
Ensure that each control of the inner and outer head siderail control panels (optional) and those of the
removable pendant control (optional) are working properly.
All controls of the foot end panel and those of the foot board panel (optional) working properly, including
Trendelenburg and lockout LED’s.
Fowler and Knee Gatch (if raised) flatten and the Fowler control motor resets itself automatically when the
two CPR handles (optional) are pulled until Fowler is flattened. Wait about 30 seconds, the time for the
Fowler motor to reset itself, and then raise the Fowler to ensure that the resetting of the motor has indeed
occurred.
Verify the Fowler, Knee Gatch and Hi-Lo movements to ensure that the motion interrupt switch integrated
to the four electric actuators is operating properly.
Auxiliary outlet (option available only with 120V beds) working properly.
Night light (optional) working properly.
Head end bumpers tightly secured to frame and working properly.
No rips or cracks in mattress cover.
Power cord is not frayed. Replace if the protective sleeve is cut or torn.
No cables worn or pinched.
All electrical connections tight.
All grounds secured to the frame.
All casters roll properly. Check caster for cuts, wear, etc.
Measure current leakage and grounding continuity of the bed and the optional auxiliary outlet. Check with
our Technical Service department for the acceptable values.
Bed Serial Number:
Completed by: _______________________________________ Date: _________________
Preventative Maintenance
WARNING
Use only replacement parts provided by Stryker.
ANNUAL CHECKLIST
To Next Page
Loading...
