8 72-1048E MM FL23SE REV A www.stryker.com
Return To Table of Contents
SPECIFICATIONS
Safe Working Load
Note: Safe Working Load indicates the sum
of the patient, mattress, and accessory
weight.
500 lbs 227 kg
Overall
Length/Width
Half-Length Siderails Raised
Full-Length Siderails Raised
90,4” x 41,3”
90,4” x 39,9”
229,6 x 104,9 cm
229,6 x 101,3 cm
Weight with Head/Foot Boards 390 lbs 177 kg
Patient Sleep Surface 35” x 78” 88,9 x 198,1 cm
Recommended
Mattress Size
Length/Width 35” x 78” or 80” 88,9 x 198,1 cm
or 203,2 cm
Maximum
Thickness
BNQ
Standard
Bed with diameter
12.7 cm (5”) casters
6” 15,2 cm
Bed with diameter
15.2 cm (6”) casters
5” 12,7 cm
Non-BNQ Standard 5” 12,7 cm
Minimum/
Maximum
Bed Height
With diameter 12,7 cm (5”) casters
11,75” to 29” 29,8 to 737 cm
With diameter 15,2 cm (6”) casters
12,75” to 30” 32,4 to 76,2 cm
Fowler Angle 0° to 62°
Knee Gatch
Angle
With Auto Contour 0° to 25°
Without Auto Contour 0° to 32°
Trendelenburg/Reverse Trendelenburg +17° to -17°
Environmental
Conditions
Transport and Storage
Ambient Temperature•
Relative Humidity•
Atmospheric Pressure•
-40° to 158°F
10 to 100%
500 to 1060 hPa
-40° to 70°C
Operating
Ambient Temperature•
Relative Humidity•
Atmospheric Pressure•
50° to 104°F
5 to 95% without condensation
700 to 1060 hPa
10° to 40°C
Electrical
Requirement
Complies with the following standards:
CSA C22.2 No. 601.1, UL 60601-1,
IEC 60601-1, 60601-2-38 and BNQ
6641-120 : 2003.
100V~, 50-60Hz, 7.5A - Two 250V, 10A Fast Acting Fuses
120V~, 50-60Hz, 4A (9.8A with 120V Optional Auxiliary
Outlet) - Two 250V, 10A Fast Acting Fuses
200V~, 50-60Hz, 3.2A - Two 250V, 6.3A Slow Blow Fuses
220V~, 50-60Hz, 2.9A - Two 250V, 6.3A Slow Blow Fuses
240V~, 50-60Hz, 2.7A - Two 250V, 6.3A Slow Blow Fuses
Stryker reserves the right to change specifications without notice.
Specifications listed are approximate and may vary slightly from unit to unit or by power supply fluctuations.
*This device has a 10% duty cycle.
Note
The Safe Working Load for the BNQ beds is of 390 lbs (177 kg).
Introduction