Stryker FL23SE - Foot Section Replacement

38 72-1048E MM FL23SE REV A www.stryker.com
Return To Table of Contents
FOOT SECTION REPLACEMENT
Tools Required:
No. 2 Phillips Screwdriver •
1/2” Combination Wrench •
Bungee Cords •
Procedure:
Completely raise the bed and apply the brakes. Flatten all sections of the mattress support. 1.
Unplug the bed power cord from the wall outlet. 2.
Lower the siderails. 3.
Lift and fold back the foot section toward the head end of the bed. Secure the section to the bed using a bungee 4.
cord.
Using the No. 2 Phillips screwdriver, remove the two lateral mattress retainers (A). 5.
Remove the foot end mattress retainer (B). 6.
Remove the foot prop rod (C). 7.
Remove the bungee cord and replace the foot section to horizontal position. 8.
Using the 1/2” combination wrench, remove the two locknuts, washers, shoulder spacers and bolts (D) linking the 9.
foot section to the thigh section and remove the defective section.
Reverse the above steps to install the new foot section.10.
Service Information