Stryker FL23SE - Full-Length Rail Replacement

28 72-1048E MM FL23SE REV A www.stryker.com
Return To Table of Contents
FULL-LENGTH RAIL REPLACEMENT
Tools Required:
1/2” Combination Wrench •
Rubber Mallet •
Procedure:
Note
Unless otherwise indicated, refer to Figure 4.1 B on pg. 26 for the following replacement procedure.
Completely raise the bed and apply the brakes. 1.
Unplug the bed power cord from the wall outlet. 2.
Raise the siderail needing repair. 3.
Loosen, if applicable, the lock ring (B) and unplug the removable pendant control (optional) cable. Remove the 4.
pendant control from the siderail by sliding it out its supports.
Using the 1/2” combination wrench, remove the four bolts and washers (A, C) holding the rail to the siderail 5.
mechanism arms. Use a rubber mallet to free the tube ends from the arms.
Note
Hold the rail firmly when removing the last bolts.
Reverse the above steps to install the replacement rail. 6.
Verify the siderail movement before returning the bed to service.7.
Service Information