EEnngglliisshh
EENN
www.stryker.com KK-7100 REV 02 1-11
Introduction
Specifications (Continued)
Standards applied
IEC 60601-1:2005+ CORR 1 (2006) + CORR 2 (2007)
Medical electrical equipment - Part 1: General requirements
for basic safety and essential performance
IEC 60601-1-2:2007
Medical electrical equipment - Part 1-2: General requirements
for basic safety and essential performance - Collateral
standard: Electromagnetic compatibility - Requirements and
tests
IEC 60601-2-52:2009
Medical electrical equipment - Part 2-52: Particular
requirements for the basic safety and essential performance
of medical beds
IEC 60601-2-54:2009*
*Only applicable when the product is equipped with
the radiolucent backrest option
Medical electrical equipment - Part 2-54: Particular
requirements for the basic safety and essential performance
of X-ray equipment for radiography and radioscopy
WARNING
Only use the input voltage and frequency as rated on the product.
CAUTION
• To minimize the risk of any electromagnetic interference, the product design follows the standard IEC 60601-1-2. To
avoid problems, use the bed in accordance with the EMC/EMI requirements in the EMC section of this operations
manual.
• Portable and mobile RF communications equipment can produce electromagnetic interference with SV1. To prevent
interference caused by portable and mobile RF communications equipment, maintain a minimum distance between
portable and mobile communications equipment and SV1 according to the EMC section of this operations manual.
To Next Page
Loading...
Need help?
General
