Stryker VisionPro User Manual

16
Troubleshooting
Before returning your display for service, consult the troubleshooting list below:
Problem Current Status Remedy
No picture Power LED on Using the OSD Menu, adjust the brightness
and contrast to maximum, or reset them to
their default settings.
Power LED o Ensure the power switch at the front and
rear of the display are set to ON.
Check if the AC power cord is properly
connected to the AC adapter and outlet.
Check that the power supply is fully
connected and functioning properly.
Power LED blinking Red Display is in sleep mode. Press
any key to wake the display.
Amber The power supply may be over or
under voltage.
Abnormal picture Oversized, undersized,
ormissing video; or
center shift.
Using the Screen Control Menu, adjust the
Phase, Frequency, Horizontal, and Vertical
settings in order to correct the display
image.
Adjust settings in Scale Mode
For VGA input only: push and hold the
rotary control for 1-2 seconds to re-sync the
video feed.
Wait a few seconds after initial sync of video
signals, or power cycle the display.
OSD error message “Out of Range” Ensure that an acceptable video source
is connected. Refer to the “Technical
Speci cations” section of this manual for a
list ofacceptable video formats.

Stryker VisionPro Specifications

General

Brand	Stryker
Model	VisionPro
Category	Monitor
Language	English