EN/07.2013/58/87
SUCTION PRESSURE LOW STATUS 46 Ye s
CONDENSER PRESSURE LOW STATUS 47 Ye s
CONDENSER PRESSURE HIGH STATUS 48 Ye s
OUTPUT POWER LIMIT STATUS 49 Ye s
EEV IN FAILURE 50 Ye s
AMBIENT TEMPERATURE INVALID 51 Ye s
SUCTION PRESSURE INVALID 52 Ye s
CONDENSER PRESSURE INVALID 53 Ye s
PERIPHERALS ERROR 54 Ye s
OUT OF ENVELOPE 55 Ye s
OVER CURRENT 56 Ye s
OVER VOLTAGE 57 Ye s
DRIVE TEMPERATURE HIGH 58 Ye s
SUPPLY VOLTAGE LOW 59 Ye s
DISCHARGE TEMPERATURE HIGH 60 Ye s
DISCHARGE TEMPERATURE INVALID 61 Ye s
INTERNAL ERROR 62 Ye s
PLC COMMUNICATION ERROR 63 Ye s
HOURS OF OPERATING OF FANS 64 Ye s
RUNTIME ERROR 65 Ye s
THERMOSTAT HIGH TEMP 66 Ye s
CONDENSER PRESSURE 67 Ye s
ALARM ACTIVE 68 Ye s
FAN 1 ERROR 69 Ye s
FAN 2 ERROR 70 Ye s
FAN 3 ERROR 71 Ye s
FC STOP BY WIND 72 Ye s
FC STOP BY FIRE 73 Ye s
EVAPORATOR FAN 1 BROKEN 74 Ye s
EVAPORATOR FAN 2 BROKEN 75 Ye s
INVERTER (using STUSNP07.00 and following) 76 Ye s
EEV DRIVER (using STUSNP07.00 and following) 77 Ye s
WATER FLOW (using STUSNP07.00 and following) 78 Ye s
INTERNAL USE 1 (using STUSNP07.00 and following) 79 Ye s
INTERNAL USE 2 (using STUSNP07.00 and following) 80 Ye s
INTERNAL USE 3 (using STUSNP07.00 and following) 81 Ye s
Commands (SNMP address= 8)
These objects are only writeable.
Command SNMP Address Trap message
ON/OFF command. Setting this object and the machine is OFF, the machine will be switched
on. Setting this object and the machine is ON, the machine will be switched off
1 No
Reset alarms 2 No
To Next Page
Loading...
