Style selections SSEB18RT - 18 In Vent-Free Gas Logs; Installing Logs

21
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use
only parts specically approved with this heater may result in property damage or personal
injury.
CAUTION: After installation and periodically thereafter, check to ensure that no yellow ame
comes in contact with any log. With the heater set to High, check to see if yellow ames
Provided Logs: 9
contact any log. If so, reposition logs according
to the log installation instructions in this manual.
Yellow ames contacting logs will create soot.
It is very important to install the logs exactly as
instructed. Do not modify logs. Use only logs
supplied with heater.
Each log is marked with a number. This
number will help you to identify the logs
when installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.
18 IN. VENT-FREE GAS LOGS
1. Insert log #1 in pin on the
left of the burner.
9. Put log #9 in the front of oor near
the burner.
3. Insert log #3 into slots in rear
log bracket on grate base.
2. Insert log #2 in pin on the
right of the burner.
6. Insert the recessed hole on the
bottom of log #6 onto pin on log 4# ,
with the other end placed
on grate
base
.
5. Insert the recessed hole on the
bottom of log #5 onto pin on log
4# , with the other end placed on
grate base.
4.
Insert log #4 into slots in rear
log bracket on grate base.
7. Insert the recessed hole on the
bottom of log #7 onto pin on log
4# , with the other end placed
on
grate base
.
8. Insert the recessed hole on the
bottom of log #8 onto pin on log
3# .