25
REMOTE CONTROL OPERATION
Fig. 23
Fig. 24
MATCHING SECURITY CODES
Program the remote receiver to LEARN a new security code by pushing in the LEARN
button the top of the remote receiver and then pressing any button on the transmitter.
NOTE: This equipment has been tested and found to comply with the limits for Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and the receiver.
· Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
NOTE: If you are unsuccessful in matching the
security code on the rst attempt, wait 1-2 minutes
before trying again --this delay allows the
microprocessor to reset its timer circuitry-- and try
up to two or three more times.
KEY SETINGS
ON - Operates unit to on position, Manually operated
solenoid ON.
OFF - Operates unit to off position, Manually operated
solenoid OFF.
MODE -Changes unit from manual mode to thermo
mode.
SET - Sets temperature in thermo mode.
ON BUTTON
OFF BUTTON
MODE BUTTON
SET BUTTON
To Next Page
Loading...
