Style selections SSEB18RT - Remote Control Lighting Instructions Model; To Turn off Gas to Appliance

24
REMOTE CONTROL LIGHTING INSTRUCTIONS MODELS
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
1. Unscrew ignitor cap and install an AAA type battery with the anode (+) pointing out.
Replace cap.
2. STOP! Read the safety information on the front and back of the warning plate.
3. Make sure manual shutoff valve is fully open.
4. Install two (2) AAA size batteries in the remote transmitter.
5. Be sure the slide switch on the front of the receiver box is in the REMOTE position.
6. Push in the control knob slightly and turn clockwise to the OFF position.
7. Wait ve (5) minutes to clear out out any gas. Then smell for gas around the heater and near
the oor. If you smell gas, STOP! Follow "B" in the safety information on the rating plate. If you
do not smell gas, go to the next step.
8. Push the control knob in slightly and turn counterclockwise to “PILOT” position and
depress for ve (5) seconds.
Note: The rst time the heater is operated after connecting the gas supply, the control knob
should be depressed for about thirty (30) seconds. This will allow gas to bleed from the gas
system.
9. With the control knob pushed in, push down and release the ignitor button.This will light
the pilot. If needed, keep pressing the ignitor button until pilot lights.
10. Continue pushing the control knob in for an additional sixty (60) seconds to allow
the thermocouple to warm up. Release the control knob.
Note: If the pilot goes out, repeat steps 7, 8, 9 and 10.
11. Rotate the control knob counterclockwise to the ON position.
12. Press the LEARN BUTTON on the front of the remote receiver box until you hear a beep.
13. Press the ON button on the remote control transmitter to light the burner. (This will also “learn”,
or program, the transmitter and the receiver).
14. If the transmitter is lost or damaged, the slide switch on the receiver can be used to operate
the heater.
TO TURN OFF GAS TO APPLIANCE
Shutting off heater
1. To turn both pilot ame and burner off, turn the gas control knob clockwise to OFF position