103
June 2014
2015 Legacy and Outback New Technology Training (Module 926)
Establishing the center line of the vehicle has been changed. New locations are used to measure
Point A and Point B.
Point A
Point B
Vehicle Center Line
Point A
The front plumb bob location (Point A) has been moved to center clip on the lower side of the front
bumper. Previously, the center of the license plate mount was used.
Suspend the plumb bob with leveling line from front center position of vehicle (center clip on lower
side of front bumper), and mark the position where the plumb bob touches the ground. (Point A)
Leveling line
Plumb bob
Point A
Point A Location
6-17
6-18
To Next Page
Loading...
