24
June 2014
2015 Legacy and Outback New Technology Training (Module 926)
Rear Window Regulator
The rear window regulator of the Legacy and Outback is described as an “I Arm” window regulator.
This type uses a single roller that moves through a channel that is attached to the window glass.
The height of the window is controlled by the position of the roller in the channel.
Rear Window Assembly I Arm And Roller
The regulator is attached to the door with 4 bolts and is easily removed through the opening in
the lower section of the door.
Regulator Mounting Points Window Taped In Position
The window glass must be taped to the door to prevent the glass from dropping after the regulator
has been removed.
1-51 1-52
1-53 1-54
To Next Page
Loading...
