68
June 2014
2015 Legacy and Outback New Technology Training (Module 926)
“Memory Height” Learning Procedure
Memory Height Button Closer Switch
Note: The ignition should be off and the PRG should be closed (Memory Height Button
should be “OFF”).
1. Open the rear gate by using the power rear gate function.
2. With the rear gate at the desired height, stop it by using the power rear gate function (use
any control button to stop the gate).
3. Press the memory switch to select the “ON” status (Lowest Position).
Power Rear Gate Button
4. With the rear gate at the desired height, press and hold the power rear gate button on the
inside edge of the rear gate until an electronic chirp is heard and the hazard warning lights
flash three times.
The electronic chirp and the flashing hazard warning lightts confirm the selected rear gate height
has been registered.
It is possible to register the height from approximately 12 in (30cm) or more from the completely
closed position.
3-36
3-37
3-38
To Next Page
Loading...
