Subaru Legacy 2015 - 6.2 Inch Display

22
June 2014
2015 Legacy and Outback New Technology Training (Module 926)
Diagnostic Trouble Codes are also available to assist with diagnostics. The data displayed provides
more detailed data than the built in Line Check function.
Both the 6.2 inch and 7.0 inch Infotainment systems are equipped with Line Check functions.
6.2 Inch Display
1. (a) Press the button to display the Audio OFF screen.
2. Touch the screen in order from (b) to (e).
(a)
(b)
(d)
(c)
(e)
Activating Line Check
Note: To exit the diagnostic mode, turn the ignition switch from ACC OFF to ON.
3. <<LineDiag>> screen is displayed.
Camera Setting
Audio Check
Line Diag
OK MIC
OK Rr_CAM
OK USB
OK AUX
OK SXM
OK UART
Connectivity Check Vehicle Signal Check
ILL
+
SPD
PKB
REV
OFF
OFF
ON
OFF
Line Diagnostic Information
This Line Check function allows the displayed signals to be checked for connection to the
Infotainment system. Activate each device to create the input signal needed to change the detection
status from NG to OK.
The Camera Setting allows adjustment of the displayed guide lines that appear when the vehicle
is in reverse gear range. Audio check rotates the sound from the radio to each speaker. Turn up
the volume to monitor each speaker.
1-47
1-48