37
June 2014
2015 Legacy and Outback New Technology Training (Module 926)
Welcome Lighting
For added night time security, the 2015 Legacy and Outback feature standard Welcome Lighting
that automatically turns on cabin illumination and exterior lights (low beams and position lamps)
as the driver approaches/unlocks or leaves/locks the vehicle.
Welcome Lights OFF Welcome Lights ON
Welcome Lighting operating conditions for approaching the vehicle
• Lighting ON
- Doors are unlocked with the remote key
- The Headlight switch is set to the “AUTO” position
- The area around the vehicle is dark (Light Sensor input)
• Lighting OFF
- Doors are relocked
- The Headlight switch is turned to a position other than “AUTO”
- The Ignition switch is turned to the “ON” or “ACC” positions
- Automatically, based on a customizable Delay Time setting (30/60/90 sec).
Welcome Lighting operating conditions for leaving/Exiting the vehicle
• Lighting ON
- When Ignition switch is turned to the “OFF” position or key is removed from ignition
- The area around the vehicle is dark (Light Sensor input)
• Lighting OFF
- The Headlight switch is turned to a position other than “AUTO”
- The “Locking” operations is performed twice from either the door handle or keyless
remote
- Automatically after Driver’s door has been opened and closed, based on a customizable
Delay Time Setting (30/60/90 sec)
- Automatically after 3 min. even if the Driver’s door is opened, but not closed. (To
conserve the battery)
2-15 2-16
To Next Page
Loading...
