11
June 2014
2015 Legacy and Outback New Technology Training (Module 926)
Bumper Cover Removal
Bumper cover removal is necessary when removing the radiator. The bumper cover (front and
rear) is attached to the body with trim clips only.
Begin bumper cover removal by removing the six clips along the top side at the indicated positions.
Upper Clips
Inner Fender Clip
Elevate the vehicle and remove the inner fender trim tab from each front inner wheel well. Raise
the vehicle high enough to remove the three lower bumper cover trim tabs and the three trim tabs
located in front of each tire.
Lower Clips
1-7
1-8
1-9
To Next Page
Loading...
