北米Model "A1760BE-A" EDITED: 2020/ 10/ 1
! Programming a New HomeLink
Button
S03AP070409
1) Indicator Light
2) HomeLink Buttons
1. Press and release the HomeLink but-
ton that you would like to program. The
HomeLink indicator light will flash orange
slowly (if not, refer to “Erasing HomeLink
Buttons” F3-82).
1) Garage door opener remote
2. Position the hand-held remote (garage
door opener remote) 1 to 3 in (2 to 8 cm)
away from the HomeLink button that you
would like to program.
NOTE
Some hand-held remotes (garage door
opener remotes) may actually train
better at a distance of 6 to 12 in (15 to
30 cm). Keep this in mind if you have
difficulty with the programming pro-
cess.
3. While the HomeLink indicator light is
flashing orange, press and hold the hand-
held remote button. Continue pressing the
hand-held remote button until the
HomeLink indicator light changes from
orange to green. You may now release
the hand-held remote button.
NOTE
Some devices may require you to re-
place this “Programming a New
HomeLink Button” step 3 with proce-
dures noted in the “Gate Operator /
Canadian Programming” section. Refer
to “Gate Operator/Canadian Program-
ming” F3-82.
Instruments and controls/Mirrors
3-80
To Next Page
Loading...
