Subaru WRX 2021 - Page 48

(46,1)
北米Model "A1760BE-A" EDITED: 2020/ 10/ 1
Before closing the door, make sure that the
belts are retracted properly to avoid
catching the belt webbing in the door.
! Rear seatbelts
S01AE0602
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the
belt out slowly. Do not let it get twisted.
. If the belt stops before reaching the
buckle, return the belt slightly and pull it
out more slowly.
. If the belt still cannot be unlocked, let
the belt retract slightly after pulling it
strongly, then pull it out slowly again.
3. Insert the tongue plate into the buckle
until you hear a click.
NOTE
The center seatbelt buckle is marked as
“CENTER”.
4. To tighten the lap part, pull up on the
shoulder belt.
5. Place the lap belt as low as possible on
the hips, not on the waist.
! Unfastening the seatbelt
S01AE060201
1) Button
1. Push the button on the buckle.
2. Retract the seatbelt slowly to prevent it
from getting tangled or twisted.
Before closing the door, make sure that the
belts are retracted properly to avoid
catching the belt webbing in the door.
Seat, seatbelt and SRS airbags/Seatbelts
1-16