TABLE OF CONTENTS
SECTION 3—SPECIFICATIONS
41 3.1 TABLE OF SPECIFICATIONS-600H, 750, 750H, 750HH
43 3.2 TABLE OF SPECIFICATIONS-825, 900, 900H
44 3.3 LUBRICATING GUIDE - COMPRESSOR
44 3.4 APPLICATION GUIDE
45 3.5 LUBRICATION GUIDE, ENGINE
46 3.6 IDENTIFICATION, LESS RUNNING GEAR (DLQ)
48 3.7 IDENTIFICATION, TANDEM AXLE (DTQ)
50 3.8 IDENTIFICATION, 4-WHEEL (DWQ)
SECTION 4—OPERATION
53 4.1 GENERAL
53 4.2 PURPOSE OF CONTROLS
54 4.3 COMPRESSOR START-UP PROCEDURE
54 4.4 COMPRESSOR SHUT-DOWN PROCEDURE
SECTION 5—MAINTENANCE
55 5.1 GENERAL
55 5.2 DAILY OPERATION
55 5.3 ENGINE COOLANT
56 5.4 MAINTENANCE AFTER INITIAL 50 HOURS OF OPERATION
56 5.5 5.5 MAINTENANCE EVERY 100 HOURS
56 5.6 5.6 MAINTENANCE EVERY 250 HOURS
56 5.7 5.7 MAINTENANCE EVERY 300 HOURS
56 5.8 MAINTENANCE EVERY 600 HOURS
56 5.9 MAINTENANCE EVERY 1000 HOURS
57 5.10 MAINTENANCE EVERY 1500 HOURS
57 5.11 PARTS REPLACEMENT AND ADJUSTMENT PROCEDURES
64 5.12 TROUBLESHOOTING GUIDE
SECTION 6—NOISE CONTROL
67 6.1 NOISE EMISSIONS WARRANTY
67 6.2 TAMPERING WITH THE NOISE CONTROL SYSTEM IS PROHIBITED
68 6.3 NOISE EMISSIONS MAINTENANCE & MAINTENANCE RECORD LOG
To Next Page
Loading...
