600H, 750, 750H, 750HH, 825, 900, 900H USER MANUAL SECTION 5
60
ELEMENT REMOVAL
1. Clean the exterior of the air filter housing.
2. Remove the cover/element assembly by
loosening the wingnut securing the cover/
element assembly.
3. Remove the cover/element assembly from
the housing by unscrewing the wingnut.
4. Clean the interior of the housing by using a
damp cloth. DO NOT blow out dirt with com-
pressed air as this may introduce dust down-
stream of the filter.
5. When it becomes necessary to remove the
secondary element, pull the element out of
the housing.
6. Install the new secondary element over the
rod.
7. With the secondary element in place, replace
the primary element.
ELEMENT INSPECTION
1. Place a bright light inside the element to
inspect for damage or leak holes. Concen-
trated light will shine through the element
and disclose any holes.
2. Inspect all gaskets and gasket contact sur-
faces of the housing. Should faulty gaskets
be evident, correct the condition immedi-
ately.
3. If the clean element is to be stored for later
use, it must be stored in a clean container.
4. After the element has been installed, inspect
and tighten all air inlet connections prior to
resuming operation.
PRIMARY ELEMENT REPLACEMENT
1. Place the element in position over the sec-
ondary element.
2. Install the cover with clean-out port pointing
down. Clamp in place using all latches
located on canister.
1. HOUSING
2. SECONDARY ELEMENT**
3. DUST COLLECTOR
4. PRIMARY ELEMENT*
5. SEALING WASHER
6. WING NUT
Figure 5-4: Filter Components
* Primary Filter Element, Part No. 048462
** Secondary Filter Element, Part No. 048463
To Next Page
Loading...
