Section 11
ILLUSTRATIONS AND PARTS LIST
115
11.18 CONTROL BOX- V-200 SUPERVISOR CONTROLLER
key part
number description number quantity
1 start, man mtr prot 1.0 -1.6 (I) - 1
2 dr, vsd ch 380/460v 140a (I) -1
3 fuse, limitron ktk-r (I) -1
4 fuse, limitron ktk-r (I) -2
5 gskt, panel Supervisor II 02250048-822 1
6 panel, cover Supervisor II 02250054-854 1
7 gskt, ctl pnl Super II 02250071-093 1
8 grip, cd n4 .125-.187 x 1/2" 02250071-379 2
9 grip, cd n4 .250-.375 x 1/2" 02250071-381 5
10 sw, vac 22"wc n4 6ft cable 5a 02250078-249 1
11 xdcr, press 0-250 psi 1-5vdc n4 02250078-933 4
12 npl, E-stop 45mm yellow 02250081-473 1
13 xfmr, pt 150va univ w/pri fh 02250083-186 1
14 switch, push-button operator e22 40mm 02250085-504 1
15 bar, ground 5 post cutler hammer 02250101-721 2
16 ctl, Supervisor III display mod 02250119-330 1
17 ctl, Supervisor III io mod 02250119-331 1
18 ctl, Supervisor III comm module 02250128-157 1
19 supt, brkt xdcr/press sw 02250129-880 1
20 decal, Supervisor front 02250130-344 1
21 panel, instrument Supervisor 02250134-463 1
22 xfmr, pt 50va 120-24 50/60 02250135-283 1
23 support, control panel (II) 02250136-227 1
24 bracket, control panel 02250136-474 1
25 spec, encl vsd s3 LS-200/160 02250145-037 1
26 blk, pwr distr 600a 02250145-195 1
27 connector, cord .312 cable x 1/2" hub 241585 2
28 switch, press no 10psi (II) 250017-992 1
29 contact, aux 1 no 250023-370 1
30 contactor, ac 3p 18v 120v chf 250025-703 1
(I) This part may vary per machine design. Consult factory with machine serial number to determine the
proper part number.
(II) This part used on water-cooled machines only.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE THE SERIAL NUMBER OF COMPRESSOR
Continued on page 117
To Next Page
Loading...
