Cyclone MKV 2 Multimedia Enclosure
Page 54.
Version 1.2
Formatting a Hard Disk Drive:
If you have installed a hard disk drive into the Cyclone MKV 2 enclosure, you
may be required to format it.
Using the remote control, navigate to the setup menu. Alternatively, press the
setup button on the remote control.
Once in the setup menu, navigate to the system tab and select “HDD Format.”
On the right side of the screen will appear the option HDD 1. Select this and
press “OK.”
A Warning notice will appear informing you that all data stored inside the HDD
will be erased.
To proceed select OK, otherwise select Cancel to exist.
When you have selected OK a format screen will appear.
On this screen select “Format” if you wish to proceed. Select “Back” to cancel
the procedure.
Once you have selected “Format,” an animation will display indicating that the
HDD is being formatted. This may take a few moments depending on the
hard disk drive.
Do not turn off the power until the formatting has been completed.
Important Notice: Please note that this process will erase any files on the
HDD. It is advised to backup all important data before
performing a system format.
Troubleshooting:
No display or sound output to TV:
This problem may have several causes.
Please check that you have selected the correct AV channel on your TV that
is assigned with the input port.
For example, if you have connected the device to the TV through the ports
labelled AV3, select Channel AV3.
If you have determined that the device has been connected correctly, it may
be set to the incorrect video output mode. To select a different video output
To Next Page
Loading...