Chapter 2 Installing the Sun XVR-600 Graphics Accelerator Software 15
Installing the Software
Use the install utility on the CD-ROM to install the Sun XVR-600 graphics
accelerator software. This utility installs necessary driver software and patches.
1. Log in as superuser.
2. Insert the Sun XVR-600 graphics accelerator CD into the drive.
■ If the drive is already mounted, type the following, and go to Step 3:
■ If the CD is not already mounted, type:
Note – The CD-ROM device might be different on your system. For example,
/dev/dsk/c0t2d0s2.
# cd /cdrom/cdrom0
# mount -F hsfs -O -o ro /dev/dsk/c0t6d0s0 /cdrom
# cd /cdrom
To Next Page
Loading...