24 Sun XVR-600 Graphics Accelerator Installation and User’s Guide • May 2004
Changing the Monitor Screen Resolution
Note – The monitor must be connected to the Sun XVR-600 graphics accelerator and
powered on for the graphics accelerator to configure to the initial monitor resolution.
For most installations, the Sun XVR-600 graphics accelerator device automatically
configures itself to the screen resolution and refresh rate for your monitor. If it is not
a Sun monitor, however, that is connected to the Sun XVR-600 graphics accelerator
device, the monitor might have the wrong screen resolution. To change the screen
resolution, use the fbconfig utility, which is used for configuring all Sun graphics
accelerators. SUNWjfb_config(1M) contains device-specific configuration
information for the Sun XVR-600 graphics accelerator.
● To access the fbconfig man page, type:
● To access the SUNWjfb_config man page, type:
host% man fbconfig
host% man SUNWjfb_config
To Next Page
Loading...
Need help?
General