Sun Microsystems XVR-600 - Connecting the Framelock Cable Assembly

Chapter 6 Sun XVR-600 Graphics Accelerator Framelocking 39
Connecting the Framelock Cable
Assembly
1. Locate the master mode connector of the framelock cable assembly (FIGURE 6-1).
2. Locate the master Sun XVR-600 graphics accelerator I/O backplate on the rear of
your system and connect the master mode connector of the framelock cable
assembly to the stereo (DIN7) connector (
FIGURE 6-2).
3. Connect the slave cable connector to a slave Sun XVR-600 graphics accelerator
stereo connector (
FIGURE 6-2).
4. Connect a second slave Sun XVR-600 graphics accelerator, if applicable, or connect
stereo glasses to the daisy-chain/stereo connector (
FIGURE 6-2).