26 Sun XVR-600 Graphics Accelerator Installation and User’s Guide • May 2004
2. Modify the file by adding the device locations for the applicable frame buffers
being used. See the following examples:
Enter the Xservers file content on a single line.
This example shows the Xservers configuration file modified for one
Sun XVR-500 graphics accelerator and one Sun XVR-600 graphics accelerator:
This example shows the Xservers configuration file modified for one
Sun XVR-600 graphics accelerator:
3. Log out, then log back in.
If you are editing the Xservers file after completing all the installation steps
outlined in Chapter 1, “Installation Process” on page 5, including the
reconfiguration, simply reboot your system.
:0 Local local_uid@console root /usr/openwin/bin/Xsun -dev /dev/fbs/ifb0
-dev /dev/fbs/jfb0
:0 Local local_uid@console root /usr/openwin/bin/Xsun -dev /dev/fbs/jfb0
To Next Page
Loading...