Sunbeam EM6910 - Water Flow and Leaking Problems

EM6910 Café Series Espresso Machine Issue: A Page 27 of 48
from group
head (with or
without
handle)
Water tank not sitting properly
Push in the water tank. Ensure tank
gauge is aligned to the front panel.
Blocked hose/brass
piping/thermoblock
Remove blockage
Damaged or disconnected
hose/piping
Replace piping.
Faulty coffee pump
Replace coffee pump
Faulty switch
Replace switch.
Faulty Control Panel
Replace Control Panel.
Faulty PCB
Replace PCB.
Water
coming out
from group
head
(without
handle)
Incorrect tension of anti-drip
spring
Change spring with correct tension.
Missing or damaged silicon
valve
Replaced silicon valve.
No hot water
Water tank empty
Refill water tank.
Water tank not sitting properly
Push in the water tank. Ensure tank
gauge is aligned to the front panel.
Steam nozzle partially/fully
blocked.
Use pin to unblock steam nozzle.
Remove and clean the steam nozzle.
Blocked hose/brass
piping/thermoblock
Unblock or replace blocked part.
Internal leaking (hose, piping,
pump)
(see separate guide on leaking problem)
Hot water micro switch
damaged or disconnected
from PCB
Replaced micro switch or reconnect to
PCB.
Faulty coffee pump
Replace coffee pump.
PCB unable to energise
coffee pump
Replace faulty PCB.
Not dumping
Dump outlet nozzle blocked
Unblock nozzle.
Coffee thermoblock outlet
blocked
Run descale cycle.
Piping/hose blocked
Replace piping/hose.
Solenoid valve jamming
Run descale cycle.
Solenoid valve faulty
Replace solenoid valve assy.