26
For communication between the battery and the hybrid inverter, after connecting the com-
munication cable to the COMM port, use the communication cable fastening tool to tighten
the cable clockwise. Then conncet to the hybrid inverter using the other end of the communi-
cation cable. Strip the insulation layer of the communication cable with a wire stripper, and
lead the corresponding CAN1_H/CAN1_L signal cable out. Cut off the redundant signal ca-
ble and warp it with a heat-shrink tubing. Signal cable 1 white and orange cable is used as
CAN1_H; and signal cable 2 orange cable is used as CAN1_L.
Please ensure that the MC4 cable are connected to same terminals, as shown
below.
4 Mounting User Manual
To Next Page
Loading...
