8. Loading and Unloading of Batteries
The batteries should be installed in a special container under the seat. They need to use lifting
tools with suitable load and volume for loading and unloading. These batteries must also meet the
CEI 21-5 standard. The dimensions of the batteries are 340mmx175mmx290.
Warning: Regarding the storage and daily charging of the batteries, the instructions of the
battery supplier must be carefully followed. All installation and storage operations shall be
carried out by relevant technicians.
Warning: It is recommended to use sealed batteries to prevent acid leakage!
Warning: It is recommended to always use protective gloves to avoid serious injuries to
your hands.
9. Operating Steps for Loading Batteries (Fig. 8)
1. Ensure that the sewage tank (A) has
been emptied.
2. Open the sewage tank (A).
3. Place the batteries (C) in the battery
room of the clean water tank (B), and
place the positive and negative poles of
"+" and "-" oppositely.
Notes:
1. Please ensure that the red terminal (+) is connected to the positive terminal (+) and the black
terminal (-) is connected to the negative terminal (-). If the connection is not correct, the machine
will run incorrectly.
2. If the above operations are not followed, the batteries will be damaged and may explode.
3. It is necessary to spray protective lubricant on battery terminals, and put cord terminal
protective sleeves on all terminals.
Note: It is recommended to use lifting tools with suitable load and volume for loading
and unloading.
To Next Page
Loading...
