14. Disassembly and Installation of Brush Tray (Fig. 12. 13)
1. Please check that the key switch (9) of the machine control panel is in the "ON" state.
2. The speed regulating knob (10) must be set to the lowest gear counterclockwise.
Note: This speed regulating knob must be turned to the lowest position, otherwise the action of
loading and unloading the brush tray will not be performed.
3. If you want to remove the brush tray from the brush tray cover (A), please just press the brush
unloading button (8) on the control panel (the green light is on), and the brush tray will be
automatically removed without manual disassembly.
4. If you want to install or replace the brush tray, firstly, the brush tray cover (A) is in a raised
state, then manually place the two brush trays (B) in the center position corresponding to the
rotating shaft of the brush tray cover (approximately in the center position, but not too far away
from the center position of the rotating shaft), and then press the brush button (12) on the control
panel (the green light is on), so that the brush tray cover (A) will brush. Then please visually
check whether the brush tray is completely covered in the brush tray cover (A). If the brush tray
is not covered in the brush tray cover (A), you can use auxiliary tools to move the brush tray to be
completely covered by the brush tray cover (A). If the brush tray cannot be adjusted, you can
press the brush button (12) again until the brush tray cover (A) will automatically rise after the
brush installation program is automatically executed. After the brush tray is successfully installed,
the brush tray will be automatically installed and raised without manual installation and lifting.
Warning: Do not let people or things near the brush during operation.
Note: Please pay attention to whether the brush is inserted normally. Otherwise, the machine will
suddenly move irregularly during operation.
Caution: Protective gloves must be used for these operations to avoid contact with sharp edges or
tips of metal objects.
To Next Page
Loading...
