15. Clear Water Tank for Water Injection (Fig. 14. 15)
1. Please check whether the valves (D) of the water pipes on both sides of the water tank have
been closed, and if the handle of the valve is in the vertical direction, it will be closed.
2. Then you should open the cover (B) on the clean water tank (A).
3. The maximum capacity of clean water added to the clean water tank is 120 liters, and the
temperature of the added clean water cannot exceed 50℃.
4. Please add the liquid detergent according to the concentration and method shown on the label
by the manufacturer. In order to avoid the possibility that excessive foam may damage the
vacuum cleaner motor, please add it according to the minimum amount required by the detergent.
The amount of detergent can also be measured by the cover that comes with the clean water tank,
and the cover can also be used as a measuring cup.
5. Cleaning chemicals, acidic or alkaline cleaners can be added, but it is required not to contain
oxidants, chlorine or bromine, formaldehyde and mineral solvents.
16. Water Flow Setting of Clean Water Tank, and Cleaning and Replacement of Clean
Water Filter (Fig. 16)
1. Adjust the fresh water flow according to the floor condition, and the buttons on the control
panel need to be adjusted as water quantity plus (5) and water quantity minus (7).
2. Regularly clean the dirt in the filter (E) under the clean water tank according to the frequency
of use (it is recommended to clean it once a week).
Warning: Every time the clean water tank solution is filled, the clean water tank must be
completely emptied.
To Next Page
Loading...
