Machine Running
17. Running Process (Fig. 17. 18. 19)
Before starting the work, the following preparations must be made:
1. Please check whether the sewage tank is empty, and if not, you should empty it.
2. Please check whether the sewage pipe has been hung in the buckle at the upper end of the
sewage tank.
3. Please turn the speed regulating knob (10) to the lowest state.
4. Please check whether the battery connector is connected to the batteries.
5. Please check whether there is a brush tray on the machine. If not, you should start the machine
before installing it.
6. Please check whether the emergency stop button switch (13) is turned on, if not, it needs to be
turned on.
7. Please turn the key switch (9) to the position “ON” on the machine control panel, and the
display screen on the instrument panel will be displayed immediately.
8. Please check whether the electronic brake is available.
9. Please check whether the valves (D) on both sides under the clean water tank have been opened.
If the handle of the valve is horizontal, it will be open.
10. Please turn the speed knob (10) higher.
11. Please hold the handle of the suction scraper with your hand and move it down, so that the
suction scraper will fall down.
12. Please press the start button (3) once (the green light is on), and the dust suction button (4)
will automatically activate (the green light is on), and then press the two driving buttons (1) on
the handle with both hands, and the machine will start to move forward. The solenoid valve will
start to work and start to distribute detergent solution. If you press any driving button (1) on the
handle, the speed will be reduced by 50% to drive. If you want to save a little electricity, ECO(11)
mode can be used.
13. If you want the machine to run in the reverse direction, you must lift the suction scraper, and
then press the reverse button (6) on the control panel. Other operations are consistent with the
forward operation.
Warning: If you want to stop the machine, you can just remove your hands.
Warning: After the start button (3) is pressed, the brush tray will be automatically put down.
After both hands hold down the driving button (1), the solenoid valve will start to work and start
To Next Page
Loading...
