9
2
Installation
1) Installation of machine head
※ Insert hinge rubber① into the table. As described in “Figure 1”, put the oil pan corner in the middle of the head
supporting rubber② and attach the table. After putting the hinge ③ in the bed hole, insert the hinge rubber① and install
the sewing machine in the table corner rubber cushion.
[Figure 1]
2) Installation of power switch box
When attaching the power switch box①, as shown in “Figure 2”,
attach it to lower right corner of the table.
①
[Figure 2]
Warning
▶ In case of installing the machine, it should be performed by the trained engineer.
▶ In case of wiring work, be sure to leave the work to an expert or an agent.
▶ The machine weight over 42kg. At least 2 persons should carry out the installing work.
▶ Plug in after finishing the installing work. In case the user press on the step by mistake, the
machine runs automatically. By doing so, it can cause the physical injuries.
▶ Connect the earthed lines.
Imperfection of the connection of the earthed lines gives rise to an electric shock or malfunction.
▶ Set the belt cover on top of the machine.
▶ In case of bending the machine backward or returning to the original condition, be sure to use
both hands. If you use only one hand, it causes physical injuries by slipping.
①
②
③
④
To Next Page
Loading...
