SunStar SPS/E-BS1202 Series User Manual (English)

Questions and Answers:

D
dylan72Aug 1, 2025
Why is my SunStar SPS/E-BS1202 Sewing Machine thread getting cut?
- M
  Madison ByrdAug 2, 2025
  The thread may be getting cut due to several reasons. Ensure the thread is inserted correctly. Reinstall the needle, paying attention to its height and direction. A damaged needle (bent, cracked, or with an abraded tip) can also cause this, so replace it if necessary. Adjust the tension of both the upper and lower threads, as well as the tension and stroke of the take-up lever spring. Finally, inspect the shuttle surface spring for cracks and replace it if needed.
S
Stephen WilsonAug 6, 2025
Why is there an error in thread tightening on my SunStar Sewing Machine?
- K
  Kristin EllisAug 6, 2025
  An error in thread tightening can be due to weak tension in either the upper or lower thread. Try readjusting the tension of both threads. It can also be caused by improper timing between the needle and shuttle, so readjust the timing for these components as well.
J
Jessica ReyesAug 11, 2025
What to do if my SunStar SPS/E-BS1202 Sewing Machine needle is bent?
- R
  Robert McdanielAug 11, 2025
  If the needle is bent, it could be due to damage such as bending, cracks, or abrasion. In this case, you should exchange the needle. Also, check if the needle is installed properly and adjust the distance between the needle and shuttle if they are in contact.
M
Michelle PooleAug 17, 2025
How to fix stitch skipping on a SunStar SPS/E-BS1202 Sewing Machine?
- B
  Benjamin PowellAug 17, 2025
  Stitch skipping can occur for several reasons. Try the following: 1. Replace the needle if it's bent or the wrong size for the thread. 2. Reinstall the needle correctly. 3. Readjust the timing between the needle and shuttle. 4. Readjust the distance between the needle and shuttle. 5. Adjust the tension and stroke of the take-up lever spring.
D
Donna LewisAug 21, 2025
What to do if there is an error on operation or drive of my SunStar SPS/E-BS1202 Sewing Machine?
- B
  Bradley MorrisAug 21, 2025
  An error during operation or drive of the machine can be caused by a few things. First, check the belt tension and adjust it or replace the belt if it's damaged. Next, inspect the fuse for the main power or circuit in the controller box and replace it if there's a shortage. Lastly, make sure the feed bracket is within its normal limits; if it's deviated, move it back into place.
B
Beth PearsonAug 27, 2025
How to troubleshoot trimming errors on a SunStar SPS/E-BS1202 Sewing Machine?
- M
  Michelle AlvarezAug 27, 2025
  If you're experiencing trimming errors, it could be due to several factors. Start by readjusting the tension of the fixed mes if there's laxity in the exchanging tension between the movable and fixed mes. If there's abrasion or a crack on the blades of either the movable or fixed mes, exchange them. Finally, check and readjust the position of the trimming cam.