3. INSTALLATION
3.1. Selecting the Mounting Area
DO NOT install the inverter in the following areas:
Areas with high salt content, such as the marine environment. It will deteriorate metal parts, causing
the parts to fail or the unit to leak water.
Areas filled with mineral oil or containing a large amount of splashed oil or steam, such as a kitchen.
It will deteriorate plastic parts, causing the parts to fail or the unit to leak water.
Areas that generates substances that adversely affect the equipment, such as sulfuric gas, chlorine
gas, acid, or alkali. It will cause the copper pipes and brazed joints to corrode, which can cause
refrigerant leakage.
Areas that can cause combustible gas to leak, which contains suspended carbon-fiber or flammable
dust, or volatile inflammable such as paint thinner or gasoline.
Areas where there may be gas leaks and settles around the unit. It can cause fires.
Areas where animals may urinate on the unit or ammonia may be generated.
High altitude areas above 4000 meters above sea level.
Environments where precipitation or humidity are above 95%
Areas where the air circulation is too low.
ALSO CONSIDER:
To Next Page
Loading...
Need help?
General