SunTech ST3310 - Status, Reset, and Preset Commands

ST3310 User Manual
20
VER ‘01’ Protocol Version
CMD_ID String Control command content
Caution : If it’s not correct the Unit ID, ignored.
4-11-1. Status Request
● Definition : Location poll, request of the status report.
Field Definitions Unit Remark
CMD_ID “StatusReq” Status request
If received, the device sends status string instantly.
<example>
<example>
[command] ST3310CMD;850000;02;StatusReq
[response] ST3310STT;850000;010;20090724;07:12:16;00129;+37.479995;+126.885815;000.029;000.00;
7;1;0;15.33;100000;2;0002
4-11-2. Reset
● Definition : Reset all of parameters.
Field Definitions Unit Remark
CMD_ID “Reset” Reset
Initialize all parameters with factory value and reboot the
device.
<example>
[command] ST3310CMD;850000;02;Reset
[response] ST3310CMD;Res;850000;010;Reset
4-11-3. Preset
● Definition : Reset all of parameters.