SunTech ST940 - Function Parameters Configuration

Doc. Title
ST940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST940
1.19
0
19-06-15
15
23 of 51
ST910;REPORT;123456789;180;180;60;3;0.10
ST910;REPORT;456789;180;180;60;3;0.10
[response]
ST910;RES;REPORT;123456789;180;180;60;3;0.10
ST910;RES;REPORT;456789;180;180;60;3;0.10
How to set ‘Function Parameters’
● The following table shows how to make a command to enable or disable the functions:
Field
Marks
Value
Meaning
HDR
“ST910”
Model Name
COMMAND
“FUNCTION”
Command Type
DEV_ID
6 or 9 char.
Digits ID of device. It is a part of IMEI. Please check the
“DEV_ID_TYPE” setting.
TURN_OFF
0 / 1
0 : Lock “power key”, you can turn off the device only by
command.
1 :If you set the device to ‘1’, you can turn off the device by
using the ‘power key’ and command.
CARRY
0 / 1
If 1, Emergency by Carry is enabled.
<Example>
[command] ST910;FUNCTION;123456789;0;1
[command] ST910;FUNCTION;456789;0;1
[response] ST910;RES;FUNCTION;123456789;0;1
[response] ST910;RES;FUNCTION;456789;0;1