Operation
NT 10000...NT 12000 39
The graphic in the lower section of the screen shows the energy fed in for the
day as a bar graph. The current period is shown as a flashing bar, as it is still in-
creasing.
Standard screen (system) You can view the system data for a CAN-networked system with this screen.
Next to the total current system output, you also see the energy yield of your
solar system and any status messages of all connected units. These are provided
with the inverter number. An ‘M‘ means that the error has occurred on the main
unit.
NOTE
The various functions are accessed via the menu. The main menu is opened
from the standard screen by pressing twice.
You can return to the standard screen at any time by pressing and holding
the key.
If a status message is shown you can open the error list directly with .
You can access other instantaneous values from the standard screen with
and .
Access rights Die Bedienung des Solar-Inverters ist in verschiedene, durch Passwörter ge-
schützte Bereiche gegliedert.
Das Passwort ist 8-stellig.
Das Passwort kann im Menüpunkt «Einstellungen – Anmeldung» eingegeben
werden.
NOTE
Erfolgt nach der Eingabe des Passwortes keine Eingabe über die Tastatur, ist
nach etwa 5 Minuten eine erneute Eingabe des Passwortes erforderlich.
ROP.Upd. The read only parameters are being updated
ParaUpd. Parameter update
Min Upd. Update of the minute values in the data logger files
Day Upd. Update of the daily values in the data logger files
Mon Upd. Update of the monthly values in the data logger files
YearUpd. Update of the annual values in the data logger files
SMinUpd. Update of the minute values in the system data logger files
SDayUpd. Update of the daily values in the system data logger files
SMonUpd. Update of the monthly values in the system data logger
files
SYerUpd. Update of the annual values in the system data logger files
To Next Page
Loading...
