Supermicro AS -2024S-TR - 2.3 Installing the Rails; Identifying the Rails

A+ Server AS -2024S-TR User's Manual
22
2.3 Installing the Rails
󰀨
procedure. 
The following is a basic guideline for installing the system into a rack with the rack mounting
hardware provided. You should also refer to the installation instructions that came with the

Identifying the Rails
The chassis comes with two sets of rack rails, one set for the right side of the chassis and
one for the left. Each set consists of an inner rail that is pre-attached to the chassis, an outer
rail that attaches to the rack, and a middle rail that slides forward in the outer rail.
Figure 2-1. Identifying the Sections of the Rack Rails
(Figure on Left is Left Rail Assembly Shown)
Inner rail – pre-attached
to the chassis
Note: The front chassis rails and the rack rails both have a locking tab. The locking tabs
hold the server in place when fully installed and pushed into the rack (its normal operating
position). The tabs also lock the server in place when extended from the rack to prevent the
server from completely coming out of the rack when pulled out for servicing.
Inner Rail
Rail Assembly
(Shown with Rails
Retracted)
This Side Faces
Outward
Locking Tab
Middle Rail
Outer Rail