Supermicro SC847 JBOD - Removing and Installing the Backplanes

SC847 JBOD Chassis Manual
4-16
4-9 Removing and Installing the Backplanes
The SC847 JBOD chassis comes equipped with a BPN-SAS3-846EL1/EL2 front
backplane and a BPN-SAS3-827EL1/EL2 rear backplane. For detailed information
and instructions on how to change the backplane settings, see Appendices C and
D of this manual.
Removing the Front Backplane
1. Power down the system and remove the power cords from the rear of the power
supplies. Remove the chassis cover.
2. Remove the two side screws securing the front backplane to the chassis.
3. Remove the four horizontal screws along the top of the front backplane.
4. 
Figure 4-17. Removing the Screws Securing the Front Backplane
Figure 4-18. Removing the Front Backplane
1
2
1
4
1
3
5. Lift the front backplane up and out of the chassis.