4-17
Chapter 4: Chassis Setup and Maintenance
Removing the Rear Backplane
1. Power down the system and remove the power cords from the rear of the power
supplies. Remove the chassis cover as described in Section 4-2.
2. Remove the two side screws (one on each side of the chassis) which secure
the rear tray to the chassis.
3. Pull the rear tray out of the back of the chassis as illustrated.
Figure 4-20. Removing the Three Screws Securing the Backplane
Figure 4-19. Removing the Screws Securing the Rear Backplane
4. Remove the nine horizontal screws going through the rear backplane.
5.
6. Lift the backplane up and out of the chassis.
1
6
1
5
1
4
1
3
To Next Page
Loading...
