Supermicro SSE-G24-TG4 - Page 19

Supermicro L2/L3 Switches Configuration Guide
19
String – alphanumeric with a character
length of 1-64.
Step 4
end
Exits the configuration mode.
Step 5
show interface description
Displays the interface description
configuration.
Step 6
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The example below shows the commands used to configure the interface description.
SMIS# configure terminal
SMIS(config)# interface Gi 0/22
SMIS(config-if)# description server1-server2
SMIS(config-if)# end
SMIS# show interface description
Interface Status Protocol Description
--------- ------ -------- -----------
Gi0/1 up down
Gi0/2 up down
Gi0/3 up down
Gi0/4 up down
Gi0/5 up down
Gi0/6 up down
Gi0/7 up down
Gi0/8 up down
Gi0/9 up down
Gi0/10 up down
Gi0/11 up down
Gi0/12 up down
Gi0/13 up down
Gi0/14 up down
Gi0/15 up down
Gi0/16 up down
Gi0/17 up down
Gi0/18 up down
Gi0/19 up down
Gi0/20 up down
Gi0/21 up down
Gi0/22 up up server1-server2
Gi0/23 up down
Gi0/24 up down
Ex0/1 up down