Supermicro SSE-G24-TG4 - Log File

Supermicro L2/L3 Switches Configuration Guide
55
1.7.4 Log File
System Logging messages can be stored as a log file in a switch’s NVRAM.
Follow the steps below to enable storing logs in a file.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
logging file <filename> max
-
entries <short (1
-
8000)>
Enable
s
storing
l
ogs in a
f
ile.
Filename – Specifies a file name of up
to 32 characters.
Short – Specifies entries that can be
stored in a file from 1-8000.
Step 3
e
nd
Exits the configuration mode.
Step 4
show logging
Displays the
Syslog
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no
logging file
”
command
disables
the
logging of
system message
s
in
a f
ile
.
The example below shows the commands used to enable storing logs in a file.
SMIS# configure terminal
SMIS(config)# logging file log1
SMIS(config)# end
SMIS# show logging file
LogFile(2 Entries)
<129> Apr 29 10:11:30 2013:INTF-1:Interface Gi0/22 status changed to UP
<129> Apr 29 10:11:31 2013:INTF-1:Interface Gi0/22 status changed to UP
SMIS#
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: disabled(Number of messages 0)